Channel Selection - AUDIOropa xepton-NX TRX Instrucciones De Servicio

How to use
2.2 Power ON / OFF
Slide the ON/OFF switch upwards to switch the
device on. The LC-display will light up and the
current setup as well as the battery status are
shown. The device is ready for use after 3 se-
conds. After 8 seconds the display goes out.
It lights up again when an entry is made and
goes out again after 8 seconds.
To switch the device off after use: Slide the ON/
OFF switch back to the lower position.

2.3 Channel selection

Switch the device on and press the MODE-button
for 3 seconds.
The symbol »CH« in the display will blink. Select
a channel of 0-7 by pressing the » « and » «
 
buttons. After the selection, wait for 3 seconds to
set the selected channel number.
Transmitters and receivers must be set to the
same channel number if they are to communica-
te with each other. The receivers must be of the
bidirectional type.
English 21