Comunello Automation RAMPART 600 Instrucciones De Uso Y De Instalacion página 19

CONTENTS
1 GENERAL PRESCRIPTIONS
1.1 SAFETY PRESCRIPTIONS
1.2 INSTALLATION PRESCRIPTIONS
1.3 OPERATING PRESCRIPTIONS
2 MODELS AND PRODUCTS DESCRIPTION
2.1 DESCRIPTION
2.2 TYPICAL INSTALLATION
3 TECHNICAL SPECIFICATIONS
4 INSTALLATION
4.1 PRELIMINARY CHECKS
4.2 APPLICATION LIMITS
4.3 INSTALLING THE RAMPART OPERATOR
4.3.1 INSTALLATION
4.3.2 LIMIT STOP ADJUSTMENT
4.3.3 MANUAL RELEASE
4.4 SWING ARM INSTALLATION
5 ELECTRICAL CONNECTIONS
5.1 SETTINGS AND CONNECTION OF ACCESSORIES
5.1.1 CONTROL AND ADJUSTMENT PANEL REFERENCES
5.1.2 ACCESSORIES CONNECTION TERMINALS (CN1)
5.1.3 MAXIMUM TRAVEL LEARNING (OPENING LIMIT SWITCH)
5.1.4 SAVING / DELETING A REMOTE
5.1.5 AUTOMATIC CLOSING
5.1.6 AUTOMATIC OR STEP-BY-STEP MODE
5.1.7 CONDOMINIUM FUNCTION
5.1.8 FORCE ADJUSTMENT
5.1.9 8K2 SECURITY DEVICE INPUT (M10-M11)
5.1.10 PHOTOCELL INPUT (M1-M4)
5.1.11 OBSTACLES DETECTION
5.1.12 COURTESY LIGHT
5.1.13 EXTERNAL FLASHING LIGHT/INDICATOR LIGHT
5.1.14 KEY SELECTOR SWITCH AND AUXILIARY PUSHBUTTONS
6 TESTING
7 MAINTENANCE
8 SPARE PARTS
9 DISPOSAL
WARRANTY
1 GENERAL PRESCRIPTIONS
1.1 SAFETY PRESCRIPTIONS
This installation manual is addressed exclusively to professionally skilled personnel. Read all the instructions carefully before starting
the installation procedures. Any operations that are not expressly set down in these instructions are to be considered prohibited;
improper use may result in damage to the product and place persons and property at risk. The manufacturer declines all liability for
the failure to observe best practices in door construction and for any possible deformation that may occur during use of the product.
Store this manual in a safe place for future reference. The design and construction of the devices of which model RAMPART is
composed and this manual are in full compliance with statutory legislation.
In consideration of potential hazards that may arise during the installation and use of RAMPART, the installation procedures must be
carried out in full compliance with the applicable laws, standards and regulations; namely:
1.2 INSTALLATION PRESCRIPTIONS
• Before starting the installation procedures make sure you have any additional devices and materials that may be required to
complete the automation system with RAMPART in consideration of the specific application.
• The automation system must not be used until the door has been made safe.
• Dispose of packaging materials in compliance with local regulations.
1.3 OPERATING PRESCRIPTIONS
• No modifications can be made to any part of the product unless specified in this manual. Unauthorized modification of the product
is likely to lead to malfunctions. The manufacturer declines all liability for damage caused by unauthorized modifications.
• The parts of the automation system must never be immersed in water or other liquids. During the installation procedures ensure
that no liquids penetrate inside the control unit or other open devices.
• If liquids penetrate any parts of the automation system disconnect the electrical power supply immediately and consult Comunello
technical service; the use of RAMPART in such conditions may give rise to potentially hazardous situations.
• Keep all parts of the RAMPART automation system away from heat sources and open flames; exposure to heat or flames may
damage the devices and cause faults, fire, or hazardous situations.
• When the equipment remains unused for a long time, remove the optional battery and store it in a dry place to avoid the risk of
COMUNELLO ®Copyright 2021 - All rights reserved
19