Publicidad
Idiomas disponibles
Idiomas disponibles
DE
GB
The kit, suitable for the extraction of injectors of DENSO brand, is
FR
formed by:
NL
• Five different types of tools (modular) to be fixed to the injector
to be extracted.
ES
Note: For the correct assembly of components
refer to the drawings in this manual and to the
IT
letters marked on the pieces.
PT
• Group for the extraction of the injectors with the aid of the
impact mass.
PL
PROCEDURE
Use protective work gloves, protective footwear,
DA
hard hat and safety goggles
• Identify, among the five in the kit, the correct tool for the
EL
extraction of the injector using the table and the assembly
drawings in this manual.
•
Before using the tool 4
rocker arms (fig. 1).
•
Before using the tool 5
3 - 4).
2
• If the tool is used 1,
- Fasten the appropriate tool for the extraction using the
thread(s) located at the side of the central body of the
injector.
- For this operation, use the screw M8 and the nut M12x1.5
included in the kit.
•
If the tool is used 4
- Screw the lateral plate B to the central body and fix them to the
injector to be extracted (fig. 5).
- Screw the lateral plate A (fig. 6) and fasten the tool to the
injector using the nut M14x1.5 included in the kit.
•
If the tool is used 5
- Keep loosen the four screws that fasten the lateral plates C (
16
METHOD OF PREPARATION
unscrew the screw between the motor
remove the U bolt /rocker arm (fig. 2 -
3
or
1
2
3
4
Publicidad
