Main Mix Level - LD Systems LD LAX12D USB Manual De Usuario

CONTROL ELEMENTS:
27

MAIN MIX LEVEL

These two faders are used to control the level of the signals sent to the L/R MAIN MIX and TAPE OUT outputs.
28 TK TO MAIN MIX
When this button is pressed, the 2-TRACK IN signal is sent to the MAIN MIX output.
29 ALT3-4 TO MAIN MIX
When this button is pressed, the ALT3-4 signal is sent to the MAIN MIX output and added to the output signal.
30 CONTROL ROOM SOURCE
These buttons are used to determine which signal is heard via the monitor speakers or headphones: MAIN
MIX, ALT 3-4, 2TK IN. Please note that these buttons are inactive in solo mode. If the selected signal cannot
be heard after the CONTROL ROOM SOURCE buttons are pushed, please first check whether the solo mode
has been activated in one of the channels.
31 PWR LED (POWER)
This LED indicates that the mixer is on.
32 PHANTOM LED
This LED indicates that phantom power has been activated.
33 PHONE/CONTROL ROOM
This control is used to adjust the level of the signal sent to the PHONE/CONTROL ROOM output.
12