LD Systems LD LAX12D USB Manual De Usuario página 17

INSERT CONNECTION
When connecting external signal processors via the main insert on the mixer, one TRS cable is required for each
send/return. The configuration of this so-called "Y" cable is depicted below.
FOR 6.3 MM STEREO PLUGS (TRS INSERT)
INSERT CABLE
Send
Return
Tip
Ring
Sleeve
NO. PRESET DESCRIPTION
00-09 Echo The input signal is sent to the output with a time delay
10-19 Echo+Verb Echo with room effect (hall)
20-29 Tremolo Amplitude modulation of the signal
30-39 Plate Hall effect: Simulation of the classic plate vocal effect
(adds brightness)
40-49 Chorus Creates the illusion of multiple instruments (voices) on the basis of a
single signal
50-59 Vocal Hall effect: Simulation of a small room with a short decay time
60-69 Rotary Simulation of typical rotary speaker effect incl. bass box
70-79 Small room Hall effect: Simulation of a bright studio room effect
80-89 Flanger + Verb Combination of a modulated delay effect plus hall
90-99 Large hall Hall effect: Simulation of a large room
WIRING CONFIGURATION / PRESET
TIP RING SLEEVE
TIP RING SLEEVE
TIP RING SLEEVE
Tip
Ring
SLEEVE TIP
Sleeve
SLEEVE RING TIP
Tip
Ring
Sleeve
Tip
Ring
Sleeve
LIST:
Tip (Send)
Sleeve
Tip (Return)
Sleeve
1
2 (Send)
3
1
2 (Return)
3
Centre (Send)
Screen
Centre (Return)
Screen
PARAMETER
Delay time: 145 - 205 ms
Delay time: 208 - 650 ms
Decay time: 1.7 - 2.1 s
Rate: 0.6 Hz - 5 Hz
Decay time: 0.9 s ~ 3.6 s
Rate: 0.92 Hz ~ 1.72 Hz
Rev. decay time: 0.8 ~ 0.9 s
Pre-delay: 0 - 45 ms
Modulation depth :
20% ~ 80%
Decay time: 0.7 ~ 2.1 s
Pre-delay : 20 - 45 ms
Decay time: 1.5 ~ 2.9 s
Rate : 0.8 Hz ~ 2.52 Hz
Pre-delay : 23 ~ 55 ms
17