ROBBE POWER PEAK Infinity 2 LI Manual De Instrucciones Adicionales página 12

The working display now appears on the
screen. The screen shows:
Time hr:min:sec Charge current Battery type
Battery voltage
The charge process is stopped by the auto-
matic charge termination circuit; alternatively
you can interrupt it by pressing the STOP
(START) button.
The status display then changes from C =
Charge to R = Ready.
2. Selecting the buzzer tone series
The tone series of the piezo buzzer can be
selected from five different options. Move to
the SOUND set-up menu and select your
preference using the -> or <- buttons.
3. Automatic mini-battery mode
A special automatic mode has been added
which provides for optimum charging of
slow-fly flight packs and small, low-capacity
receiver batteries.
The Current Select menu is now expanded as
follows:
- Current select MAN = manual
- Current select AUTO = automatic mode for
standard batteries
- AUTO MINI C.S. = automatic mode for
small batteries
Supplementary operating instructions
POWER PEAK Infinity 2 LI
Status
Capacity
12
4. Tx-Rx output with automatic charge ter-
mination
The Tx-Rx charge output now also features
an automatic Delta-Peak charge termination
circuit which automatically ends the charge
process when the transmitter or receiver bat-
tery is fully charged.
Note:
The charge process at the Tx-Rx output can
be started by pressing any button.
If no battery is connected to the "Output 0.1
... 5A" output, the warning "Check! NO BAT-
TERY INSERT BATTERY" appears on the
screen; this only applies to the main charge
output
Specification:
Input:
Cell count:
NC / NiMH battery:
Lead-acid battery:
Lithium battery:
Charge current:
Discharge current:
Charge termination:
NC / NiMH:
Lead-acid / Lithium batteries:
Order No.
8294Li/D
11 - 15 Volts DC
1 ... 30 cells
1 ... 6 cells
1 ... 5 cells
0.1 ... 5 A
0.5 ... 5 A
Automatic
Digital Delta-Peak
Voltage-dependent