Daikin FWEC3 Manual De Instalación Y De Uso página 34

WATER CONTROL
Enabling of the dehumidification function is tied to the water
temperature. The related enabling logic is described below.
If enabling conditions do not exist, the dehumidification function
will be temporarily inhibited. The same will occur in the event
that the sensor is disconnected.
N.B.: once the target level of humidity is reached or the
controller is switched off, the dehumidify option
will be unselected.
DISPLAY
The display shows the following information:
 D ehumidify ON: symbol lit
 D ehumidification temporarily inhibited: flashing symbol
.
PROGRAMMING OF TIME SCHEDULES
GENERAL FUNCTIONING
Time schedules are programmed by setting the dedicated
parameters (H parameters) in a suitable manner and in the
correct sequence. The procedure for accessing parameters
and the meaning of each parameter are thoroughly described
in the paragraphs below. It is possible to set two different types
of time schedules:
 O N/OFF time programming: each time slot can be
associated with a controller ON or OFF status, so that the
controller will automatically switch on or off according to
the time of day.
 t emperature SETPOINT programming according to time
of day: each time slot can be associated with a SUMMER
temperature SETPOINT (for cooling) and a WINTER
temperature SETPOINT (for heating), which will be
automatically used by the controller as the temperature
SETPOINT (adjustable by the user within a range of ±2°C)
according to the time of day and current operating mode.
Two daily profiles can be defined, each of which divided into
three time slots. Each day of the week can be associated with
one profile or the other.
DAILY PROFILE 1 (FIGURE 6):
WHERE
A SLOT 1
B SLOT 2
C SLOT 3
DAILY PROFILE 2 (FIGURE 7):
A SLOT 1
B SLOT 2
C SLOT 3
Installation and user manual
12
WATER TEMP.
.
ACCESS TO PARAMETER CONFIGURATION PROCEDURE
 P ush at the same time
 U se keys to modify the display value up to the
password value "5", and press
have access to the parameters.
 U se keys to scroll the various parameters (see
"Parameter list").
 P ress to confirm the parameter change (the value
will start flashing).
 U se keys to change the value.
 P ress to save the new value setting or
cancel the modification.
 A fter completing the modification of the parameters con-
cerned press key to exit the procedure.
and .
. If it is correct, you will
to
FWEC3
Advanced plus electronic controller
FC66002765