Stroller Operation
Adjust Recline
Recline Backrest
There are 4 angles for the backrest.
To recline the backrest, squeeze the recline handle on the back of the seat
To raise the backrest, push up.
!
Make sure the recline is set properly for use.
Use Armbar
The armbar can be pulled up on both left and right sides.
- 1
Press armbar release button
10
, and then pull up the armbar
component, and then push down to lock.
Tip
Armbar can be open for easily placing and removing.
Use Buckle
Release Buckle
11
Press the center button to release the buckle.
Lock Buckle
Match the waist belt buckle with the shoulder buckle
A click sound means the buckle is locked completely.
!
To avoid serious injury from falling or sliding out, always secure your child with harness.
!
Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand.
!
Do not cross the shoulder belts. This will cause pressure on child's neck.
Use Shoulder & Waist Harnesses
!
In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder and waist harnesses are at proper height and length.
- 1
13
Shoulder harness anchor A
- 2
13
Shoulder harness anchor B
13
- 3
Slide adjuster
For larger child, use shoulder harness anchor A and the highest shoulder slots. For smaller child, use shoulder
harness anchor B and the lowest shoulder slots.
To adjust the position of the shoulder harness anchor, turn the anchor to be level with the short side facing
forward. Thread it through the shoulder harness slot from back to front
- 2
14
is closest to child's shoulder height.
Use slide adjuster to change the harness length.
- 2
15
Press the button
, while pulling the waist harness to proper length
11
8
, pull down on the backrest.
- 2
10
. Align the armbar end with matching
- 1
- 2
12
12
, and click into the center buckle.
- 3
12
- 1
14
. Rethread it through the slot that
- 1
15
- 3
15
.
Adjust Calf Support
There are two recline angles, 1-2
To raise calf support, push the calf support from position 1 to position 2
To lower calf support, press the adjustment buttons on both sides of the calf
-1
support
17
, and rotate the calf support downwards.
9
Adjust Handle
Handle can be adjusted to 2 positions.
To adjust the handle, press the left and right handle adjustment buttons at the same time
handle to a desirable position.
Use Hood
To open the hood, pull canopy toward front and press stretchers down on both sides.
To fold the hood, pull up the stretchers on both sides
Use Front Swivel Lock
Pull up the front swivel locks to maintain the moving direction.
Tip
It is recommended to use swivel locks on uneven surfaces.
Use Brake
To lock wheels, step on the brake lever as
stepped on.
Lift the brake lever to release wheel.
Tip
The brake must be engaged when placing and removing children.
Tip
Always apply brake when stroller is in stopped position.
Tip
To ensure brake is fully on, gently rock the stroller backwards and forwards before releasing the handle
Fold Stroller
Before folding, pull up canopy stretchers.
Push secondary lock
sound means the stroller is folded completely.
Accessories
Accessories may be sold separately or may not be available depending on region.
Use with Joie Child restraint
When using with Joie child restraint gemm, please refer to the following instructions.
!
If you have any problems about using the infant child restraint, please refer to their own instruction manuals.
!
Please don't fold stroller when attaching the child restraint.
16
for adjustment.
- 2
17
- 2
18
- 1
19
and pull canopy toward back.
20
21
. The stroller wheels are locked on the condition that the brake is
- 1
19
- 1
- 2
22
and squeeze one-hand-fold handle
22
23
16
.
- 1
18
, rotate the
19
. Push the stroller forward to fold. A click
12