Stroller Operation; Use Buckle; Use Shoulder & Waist Harnesses; Adjust Calf Support - Joie pact lite Manual De Instrucciones

Stroller Operation

Use Buckle

see images
-
15 16
Release Buckle
Press the center button to release the buckle.
Lock Buckle
Match the waist belt buckle with the shoulder buckle
and click into the center buckle.
the buckle is locked completely.
! To avoid serious injury from falling or sliding out, always se-
cure your child with harness.
! Make sure your child is snugly secured. The space between
the child and the shoulder harness is about the thickness of
one hand.
! Do not cross the shoulder belts. This will cause pressure on
a child's neck.
Use Shoulder & Waist Harnesses
see images
-
17 19
! In order to protect your child from falling out, after your child
is placed into the seat, check whether the shoulder and
waist harnesses are at proper height and length.
- 1 Shoulder harness anchor A
17
- 2 Shoulder harness anchor B
17
- 3 Slide adjuster
17
For larger child, use shoulder harness anchor A and the
highest shoulder slots. For smaller child, use shoulder harness
anchor B and the lowest shoulder slots.
19
15
- 1,
16
- 2 A "click" sound means
16
- 3
16
To adjust the position of the shoulder harness anchor, turn the
anchor to be level with the side facing forward. Thread it through
the shoulder harness slot from back to front.
through the slot that is closest to child's shoulder height.
Use slide adjuster to change the harness length.
Press the button - 2, while pulling the waist harness to proper
19
length. - 3
19
Adjust Backrest
see images
-
20 21
Recline Backrest
Pull tab to recline backrest.
! Hold the backrest with the other hand if a child is already
seated in the stroller.
Raise Backrest
Hold both left and right strings and push up the angle adjuster
to raise backrest.
21
! Make sure the recline is set properly for use.

Adjust Calf Support

Only available on some models
see images
22
The calf support has 2 positions.
Raise Calf Support
To raise the calf support, just push it upwards. A "click" sound
means the calf is locked completely.
Lower Calf Support
Press the adjustment buttons on both sides of the calf support
- 1, and rotate the calf support downwards.
22
- 1 Rethread it
18
- 1
19
20
- 2
22
- 2
18
20