Tabla de contenido
Publicidad
Trouble
Low power
Motor will not run
Tool will not impact
SAVE THESE INSTRUCTIONS. DO NOT DESTROY.
MAINTENANCE SECTION
TROUBLESHOOTING GUIDE
Probable Cause
Dry Motor
Inadequate air supply
Dirty Inlet bushing Screen
Worn or broken Vanes
Worn or broken Cylinder and/or
scored End Plates
Dirty motor parts.
Damaged Reverse Valve
Incorrect assembly of motor
Insufficient lubricant in impact
mechanism.
Broken or worn impact mecha-
nism parts
Impact mechanism not assembled
correctly.
27
Solution
Daily, inject 3 cc of Ingersoll- -Rand No. 50 Oil into
the inlet and run the tool to lubricate the motor.
Install proper air supply and connection. Refer to
Dwg. TPD905- -1 and Dwg. TPD1674- -1 on
pages 3 and 4.
Using a clean, suitable, cleaning solution in a well
ventilated area, clean the Inlet Bushing Screen.
Replace a complete set of Vanes
Examine Cylinder. Check outside and ends for
wear or damage and inside for scored or wavy bore.
Replace Cylinder if any of these conditions exist.
Replace End Plates if they are scored.
Disassemble the Tool and clean in a clean, suitable,
cleaning solution in a well ventilated area.
Assemble the Tool and inject 3 cc of the
recommended oil into Inlet and run Tool to
lubricate internal parts.
Replace Reverse Valve. Refer to Installation of
Reverse Valve.
Disassemble motor and replace worn or broken
parts and reassemble. Refer to Assembly of the
Motor.
Lubricate impact mechanism through Hammer
Case Grease Fitting using the recommended grease.
Remove Hammer Case Assembly and examine im-
pact mechanism parts. Replace any worn or broken
parts.
Refer to Assembly of Impact Mechanism.
Publicidad
Tabla de contenido
