Tabla de contenido
Publicidad
LUBRICATION
Ingersoll- - Rand No. 50
Ingersoll- - Rand No. 115- - 1LB for routine external
lubrication of the impact mechanism through the Hammer
Case Grease Fitting.
Use Ingersoll- - Rand No. 105- - 1LB or Ingersoll- - Rand
105- - 8LB when disassembling and assembling the impact
mechanism.
Always use of an air line lubricator. We recommend the
following Filter- - Lubricator- - Regulator Unit:
For International - - C16- - C3- - A29
For USA - - No. C11- - 03- - G00
Do not mark any nonmetallic surface on this tool with
customer identification codes. Such actions could affect
tool performance.
PLACING TOOL IN SERVICE
2131
TPD1885
Letter/Number
Date Code
Location
A __ __ __ __
3
INSTALLATION
Air Supply and Connections
Always use clean dry air. Dust, corrosive fumes and/or
excessive moisture can ruin the motor of an air tool. An
air line filter can greatly increase the life of an air tool.
The filter removes dust and moisture.
Be sure all hoses and fittings are the correct size and are
tightly secured. See Dwg. TPD905- - 1 for a typical piping
arrangement.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
FILTER
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905- -1)
Publicidad
Tabla de contenido
