Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
cod.92004 – TDU 210PS
Setting up the machine (fig. A1 & A2)
The machine can be set up in two operating positions: in the cut-off saw position (fig. A1) and in the table saw
position (fig. A2).
After use, the machine should always be left in the table saw position.
Setting up for use in the cut-off saw position:
•
Loosen the screw (4) a few turns.
•
Raise the upper table top (18) while holding the head at the handgrip (2) in the lowest position. Tighten
the screw (4).
•
Pull out the lock knob (8).
•
Carefully raise the head.
•
Remove the lower guard (16).
Adjusting the sawing angle (fig. A1 & B)
The default angle between the saw blade and the saw table is 90°.
Use a set square to check the angle between the saw blade and the table (12). If the angle does not
•
measure 90° adjust as follows:
Loosen the lock knob (6) and move the head so the saw blade reaches a 90° angle.
•
•
Loosen the locknut on the adjusting screw (20) and screw the adjusting screw in or out to achieve a 90°
angle. Retighten the locknut.
•
Tighten the lock knob (6).
Setting up for use in the table saw position:
Place the lower guard (16) on the lower table top (12).
•
Push in the release knob (3) and lower the head.
•
The saw blade is fully covered by the lower guard.
Push in the lock knob (8).
Loosen the screw (4) a few turns.
•
Carefully lower the upper table top (18). Tighten the screw.
•
Adjusting the bevel angle (fig. A1 & C)
The max. bevel angle is 45°.
•
Loosen the lock knob (6) and turn the head to the utter bevel angle.
•
Check the bevel angle using the scale (7). If the angle does not measure 45° adjust as follows:
•
Loosen the locknut on the adjusting screw (21) and screw the adjusting screw in or out to achieve a 45°
angle. Retighten the lock nut.
Adjusting the riving knife (fig. D1 & D2)
Raise the head.
•
Loosen the screws (22) a few turns.
•
Adjust the riving knife (23).
•
Tighten the screws.
•
Ensure that the riving knife is always correctly adjusted: The distance between the riving
knife and the teeth of the saw blade is less than 5 mm.
Replacing the saw blade (fig. E1 & E2)
Raise the head.
•
Remove the upper blade guard (19), the riving knife (23) and the table insert (24).
•
Hold the flange (25) using the spanner (26).
•
•
Use the spanner (27) to loosen the fixing screw (28) and remove it.
•
Remove the outer flange (25), the old saw blade (29), and the inner flange (30).
•
Clean the flanges.
•
Place the inner flange, the new saw blade, and the outer flange. While placing the saw blade, make sure
that the teeth point to the direction rotation as shown.
Replace the lock screw and tighten it firmly.
•
19
Publicidad
Tabla de contenido
