50 Hour Or Weekly Routine Maintenance; Routine Adjustments - Ingersoll Rand BX-60WH Manual De Utilización Y Mantenimiento

2. Remove wing nut ( , [Figure 8]) and the element
assembly.
3. Separate foam element ( , [Figure 8]) from paper element
. Check both elements for holes or tears and replace if
necessary.
4. To clean the foam element wash in a solution of household
detergent and warm water, then rinse thoroughly or wash in
a nonflammable solvent. Allow to dry thoroughly. Soak the
element in clean engine oil and squeeze out excess oil.
Too much oil will cause engine to smoke on initial start-up.
5. To clean the paper element, tap lightly on a hard surface to
remove dirt or blow out with compressed air from the inside
out. Do not use a brush to remove dirt. This can push dirt
into the fibers. Replace the filter if it is excessively dirty.
6. Wipe out the inside of the cover with a damp cloth.
7. Reassemble the air cleaner.
CAUTION
If the air cleaner element is seriously contaminated,
start-up failure, poor output and malfunctions of the engine
may result.
Never run the engine without the air cleaner. Rapid engine
wear will result.
Fastening Hardware
Check all fastening hardware to ensure it is all adequately
tightened and that none is missing or broken.

50 HOUR OR WEEKLY ROUTINE MAINTENANCE

Check Engine Oil
CAUTION
Running the engine with insufficient oil can cause serious
engine damage.
Be sure machine is on a firm level surface and stopped.
1. Place the machine on a stable level surface and stop the
engine.
2. Remove oil filler cap/dipstick ( , [Figure 9]) and wipe off
.
the dipstick
Figure 9
3. Place the dipsick back into the engine but do not screw it in.
Remove the dipstick and check the oil level.
4. If the level is low, fill to the top of the oil filler neck ( ,
[Figure 9]) with the recommended oil.
5. Place the oil filler cap/dipstick into the engine and screw it
into place. Wipe up any excess oil.
Change Engine Oil
1. Stop the engine, loosen and remove the drain plug ( ,
[Figure 9]), drain the oil and reinstall the drain plug before
refilling with oil.
2. Fill to the top of the oil filler neck ( , [Figure 9]) with the
recommended oil. Install the filler cap/dipstick ( ,
[Figure 9]).
Always use the best grade of fresh, clean oil. Contaminated oil,
poor quality oil and shortage of oil will cause damage to engine
or shorten the engine life.
Capacity of engine oil
Recommended engine oil
Use class SE, SF (API classification) or higher grade oil.
Initial oil change
Thereafter

ROUTINE ADJUSTMENTS

Engine RPM
Adjust the engine rpm as specified in the engine manual.
V-Belt Tension
Adjust the v-belt tension so that a light pressure on the belt
between the two pulleys deflects the belt 5 to 10 mm.
BX-60WH / BX-80WH / BX-120WH Plate Compactors
11-EN
BX-60WH: 0.4 liters
BX-80WH/BX-120WH: 0.6 liters
SAE 10W30
After 20 hours of operation
Every 50 hours of operation
Operation & Maintenance Manual
EN