Niagara ECOLOGIC 1.6 GPF Instrucciones De Instalación, Guía Para La Solución De Problemas Y Garantía página 3

6.
7.
8.
9.
FILL VALVE
TOILET SEAT INSTALLATION INSTRUCTIONS
EcoLogic toilets are supplied as a complete unit, including all components which are designed to work in conjunction with each other, to give satisfactory service and reliability.
®
Substitution with any other parts of components not supplied by Niagara for EcoLogic
consequent water damage.
In cases where parts are substituted, Niagara can not be held liable for any damages. In order to have your new toilet provide the best performance, we assemble all of the
components at the factory. Each fill valve is designed to meet the highest code and flushing requirements.
Install the plastic washer (be sure that the side marked "top" is facing up), round
metal washer, and full hex nut. DO NOT OVERTIGHTEN. Cut off any excess bolt
length and snap the bolt cap in place. Run a bead of caulk around the base of the
toilet for a finished look and to meet plumbing codes.
Install the toilet tank which has been factory assembled. The gasket seal is between
the bowl and the bottom of the tank and is ready to set in place. Place the tank on the
toilet bowl. Slide the tank toward the front or back of the bowl until the desired gap,
normally 1/2 to 1 inch, is obtained between the tank and the wall. Secure the tank in
place with the two (2) metal washers and two (2) wing nuts provided.
DO NOT OVERTIGHTEN.
Connect the water supply to the toilet fill valve and hand tighten. Carefully connect
the water supply to the shut-off valve.
RAISE WATER LEVEL
Open the shut-off valve slowly and check for leaks. Fill the EcoLogic
LOWER WATER LEVEL
dump bucket to the water line. Adjust the level if necessary by turning
the black screw on top of the float. Turn the screw to the right to lower
the water level or to the left to raise the water level.
(Seat included in All-In-One units only)
1. Place the seat on the toilet, aligning the holes of the seat with the holes in the
back of the toilet bowl.
2. Insert the screw through the holes to secure it with the nut from the bottom of the toilet, with
the nut's tapered end on top.
3. Adjust seat position for best fit on toilet bowl.
4. Secure nut from the bottom of the toilet, use a regular screwdriver to tight the fit. (See picture)
CAUTION: DO NOT OVERTIGHTEN THE SCREW AS IT MAY CAUSE DAMAGE ON SEAT.
5. Push the decorative cap down.
Check out our instructional videos at: niagaracorp.com/troubleshooting
toilets could result in product failure, potential flooding, a failure of the installation, and
®
®