Electrolux EDC 77570W Manual De Instrucciones página 11

shows an alarm code (e.g. E21).
E.27
" " D D r r y y i i n n g g " "
This symbol appears on the dispay that
the appliance is in the drying phase.
" " C C o o o o l l i i n n g g " "
This symbol appears on the dispay that
the appliance is in the cooling phase.
At the end of drying, there is a 10 minute
cooling phase to cool the laundry.
" " A A n n t t i i c c r r e e a a s s e e " "
This symbol appears on the dispay at
the end of the cooling phase, during
the anti-creasing phase and at the end
of the programme.
I I n n d d i i c c a a t t o o r r l l i i g g h h t t s s
These lights indicate the following functions:
" " W W a a t t e e r r r r e e s s e e r r v v o o i i r r f f u u l l l l " " l l i i g g h h t t
This light comes on at the end of the
programme to remind you that the water
reservoir must be emptied out. If this light
illuminates during a programme this means
that the water reservoir is full. The buzzer
sounds, the programme stops, the light of
the Start/Pause button flashes.
" " F F i i l l t t e e r r c c l l e e a a n n i i n n g g " " l l i i g g h h t t
It comes on every 80 cycles to remind you
that the condenser must be cleaned.
" " C C o o n n d d e e n n s s e e r r c c l l e e a a n n i i n n g g " " l l i i g g h h t t
This light illuminates at the end of the
programme to remind you that the
filters must be cleaned.
At the end of the programme
All drying programmes end with a 10
minute cooling phase.
You may remove the laundry after this
phase. The lights
minate.
and , and illu-
The display shows a static zero. If the laun-
dry is not removed at the end of the cycle,
the dryer performs an a a n n t t i i - - c c r r e e a a s s i i n n g g phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the
dryer will stop automatically at the end of
the anti-creasing phase.
Lights and
buzzer sounds for 2 minutes.
If you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
Turn the programme selector dial to " " O O " "
to switch the machine off. Remove the
laundry from the drum and carefully
check that the drum is empty. The appli-
ance is switched off.
Remove the laundry.
I I f f y y o o u u o o p p e e n n a a n n d d t t h h e e n n c c l l o o s s e e t t h h e e d d o o o o r r b b e e f f o o r r e e
t t u u r r n n i i n n g g t t h h e e s s e e l l e e c c t t o o r r d d i i a a l l t t o o " " O O " " a a l l l l t t h h e e l l i i g g h h t t s s
c c o o r r r r e e s s p p o o n n d d i i n n g g t t o o t t h h e e p p h h a a s s e e s s m m a a k k i i n n g g u u p p
t t h h e e p p e e r r f f o o r r m m e e d d p p r r o o g g r r a a m m m m e e c c o o m m e e o o n n . .
A A f f t t e e r r e e a a c c h h u u s s e e
• Clean the filters.
• Empty the water reservoir.
I I m m p p o o r r t t a a n n t t ! !
If the drying programme has to be
stopped before it reaches the end, we
recommend that you turn the pro-
gramme selector dial to position Cooling
and wait until the end of this cooling
phase before removing the laundry. This
will avoid a build-up of heat inside the
appliance.To do this first turn the dial to
"O O " " and then to Cooling
depress Start button.
M M o o d d i i f f y y i i n n g g t t h h e e p p r r o o g g r r a a m m m m e e
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to "O O ". Select the
new programme and press the Start
button .
use electrolux 11
remain lit and the
and
GB