Cycle Option Buttons; My Cycle - Kenmore 796.8884 Serie Guia De Uso Y Cuidado E Instrucciones De Instalacion

CYCLE OPTION BUTTONS

Your dryer features several additional cycle options to
customize cycles to meet your individual needs. Certain
option buttons also feature a special function (see
the following page for details) that can be activated by
pressing and holding that option button for 3 seconds.
To Add Cycle Options to a Cycle:
1. Turn on the dryer.
2. Turn the Cycle Selector Knob to select the desired
cycle.
3. Use the Cycle Modifier buttons to adjust the settings for
that cycle.
4. Press the Cycle Option button(s) for the option you
would like to add. Aconfirmation message will be
shown in the display.
5. Press the Cycle Selector Knob to start the cycle.
The dryer will start automatically.

MY CYCLE

MY CYCLE allows you to store any special
combination of settings that you use
frequently. It allows you to save drying levels,
temperatures, times, and options for a cycle,
and then recall them at the touch of a button.
To store MY CYCLE:
1. Turn on the dryer.
2. Select a cycle.
3. Use the cycle modifier buttons to adjust the settings for
that cycle.
4. Set any other desired cycle options.
5. Press and hold the MY CYCLE button for 3 seconds.
You will hear two beeps to confirm the settings have
been stored.
HOW TO USE
WRINKLE GUARD
Selecting this option will tumble the load
periodically for a few seconds without heat.
This will continue for up to 3 hours after the
selected cycle, or until the door is opened.
This prevents wrinkling of unremoved dry
items until they can be removed.
DAMP DRY SIGNAL
With this option, the dryer will beep when
the load is approximately 80% dry. This allows
you to remove faster drying lightweight items
or items that you would like to iron or hang
while still slightly damp. This option is only
available with Sensor Dry cycles.
IMPORTANT: You can only save one My Cycle program at
a time. If you press and hold the MY CYCLE button for
3 seconds, you will overwrite any previously stored My
Cycle settings.
To recall MY CYCLE:
1. Press and release the MY CYCLE button. The stored
settings will be displayed.
2. Press and release the Cycle Selector Knob to start
the cycle. The dryer will start automatically.
NOTE: Once My Cycle has been recalled, any of
the memorized modifiers or options can be adjusted.
However, if the Cycle Selector Knob is rotated,
My Cycle will be cancelled.
23