Stopping The Engine; Maintenance Schedule - Imer Group JARD 7 EX Manual De Usuario

STOPPING THE ENGINE

Move speed control to IDLE position [Fig. 26];
1.
Turn the ON/OFF switch to OFF (STOP) position [Fig. 27];
2.
3. Slightly pull the recoil starter rope until it becomes a bit difficult. Let it come back to initial position
[Fig. 20].
IN CASE OF LOW TEMPERATURE (≤ 0°C)
After stopping the engine:
1. Remove the drain plug from the pump body [Fig. 28];
2. Drain the water from the body pump [Fig. 29];
3. Empty water from suction and discharge pipes.

8. MAINTENANCE SCHEDULE

□ This maintenance schedule gives only guidelines. In case of heavy duty operation (dirty or dusty
environment), perform maintenance more often.
NOTE
○ This sign indicates that the user can perform the
● This sign indicates that a special tool is required to perform the task. Only qualified technicians
are authorised to perform these interventions. Contact a specialist.
Operation to perform
Engine oil
Air cleaner
Spark plug
Spark arrester
Engine cooling fins
Nuts, bolts, fasteners
Idle speed
Valve clearance
36
WARNING
Check level
Change
Check
Clean
Replace
Check, adjust
Replace
Clean
Check
Check (if necessary to
tighten)
Check, adjust
Check, adjust
intervention.
Operating Hours
20 h 25 h
Each use
○
○
○
○
50 h 100 h 300 h
○
○
○
○
○
●
●
○