NGP SLAL-250-PDKIT Instrucciones De Instalación página 2

30"
36"
32"
28"
24"
Track
2"
36"
End Bracket Allowance (2")
Header Board
Track
Hanger
End Bracket
Opening End
24"
32" 28"
30"
Nailing Strip
Nailing Strip
Header
Board
2. Cutting Header
If door width does not match pre-marked widths, follow
instructions for "Cutting Header for Odd-sized Doors" in
the next step.
The Header Track Assembly does not require cutting
if your door panel width is 36". For shorter widths, cut
Header Track Assembly as follows:
a) At the door marking that corresponds with the
appropriate door width, cut Header Board and Nailing
Strip on both sides (do not cut metal track).
b) Remove cut off ends and discard.
c) Turn Header Track Assembly over and cut metal track
2" shorter than header.
3. Cutting Header for Odd-Sized Doors
a) Cut Nailing Strips to door panel width plus 7/8".
b) Cut Header Board by measuring 2 times door width
plus 1".
c) Turn Header over and cut the metal track 1 3/8"
shorter than Header Board.
4. Installing Hangers INTO TRACK
From the open end of track, slide both Hangers into
track as shown.
Installing Hangers with Soft Close into track, refer to
Soft Close Instructions that are supplied with Soft Close.
5. Installing End Bracket
Use two (2) #8 x 5/8" screws and attach end bracket to
the opposite end of Header Track Assembly.