Disassembling Your Mask For Cleaning; Cleaning Your Mask - ResMed AirFit F30 Guia Del Usuario

Disassembling your mask for cleaning

If your mask is connected to a device, disconnect the device air tubing
from the mask elbow.
1. Undo the fastening tabs on the upper headgear straps and pull them
from the frame. Keep the magnetic clips attached to the lower
headgear straps.
2. Squeeze the side buttons on the elbow and detach from the frame.
3. Hold the top and bottom of the cushion and separate from the frame.

Cleaning your mask

After each use: QuietAir elbow, frame, cushion
Weekly: Headgear
1. Soak the components in warm water with a mild liquid detergent.
Ensure that there are no air bubbles while soaking.
2. Shake the components vigorously in the water for at least one minute
and hand wash with a soft bristle brush. Pay particular attention to all
connection areas, elbow vent holes and valves.
3. Thoroughly rinse the components under running water.
4. Squeeze the headgear to remove excess water. Leave the
components to air dry out of direct sunlight.
If the mask components are not visibly clean, repeat the cleaning steps.
4