Disassembling Your Mask For Cleaning; Cleaning Your Mask - ResMed AirFit F30i Guia Del Usuario

Ocultar thumbs Ver también para AirFit F30i:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Disassembling your mask for cleaning

If your mask is connected to a device, disconnect the device air tubing
from the mask elbow.
1. Undo the fastening tabs on the upper headgear straps and pull from
the frame. Keep the magnetic clips attached to the lower headgear
straps.
2. Squeeze the side buttons on the elbow and detach from the frame.
3. Grip the frame connector and lift to unclip from the cushion. Repeat
on the other side.

Cleaning your mask

If there is any visible deterioration of a mask component (cracking,
crazing, tears etc.) the component should be discarded and replaced.
Daily/After each use: Cushion
Weekly: Headgear, frame and elbow
1. Soak the components in warm water with a mild liquid detergent.
2. Hand wash the components with a soft bristle brush. Pay particular
attention to the vent holes in both cushion and elbow.
3. Thoroughly rinse the components under running water.
4. Leave the components to air dry out of direct sunlight.
If the mask components are not visibly clean, repeat the cleaning steps.
Make sure that the vent holes and anti-asphyxia valves are clean and
clear.
4

Publicidad

Tabla de contenido
loading

Tabla de contenido