General Guidelines; Cleaning And Maintenance; Discharging The Device Before Maintenance - Perel GIK07N Manual Del Usuario

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of
this manual.
Keep this appliance away from dust and extreme temperatures.
Protect this appliance from shocks and abuse. Avoid brute force
when operating the appliance.
Familiarise yourself with the functions of the appliance before actually using it.

All modifications of the appliance are forbidden for safety reasons. Damage

caused by user modifications to the appliance is not covered by the warranty.
Only use the appliance for its intended purpose. Using the appliance in an

unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not

covered by the warranty and the dealer will not accept responsibility for any
ensuing defects or problems.
Keep this manual for future reference.

4. Operation
Refer to the illustrations on page 2 of this manual.
Flying insects are attracted by the UV light [D], which is mounted behind a high-
voltage electrical grid [B]. When touching the grid, the insects are electrocuted
and fall into the collector [C].
1. Place or hang the insect killer in a dry location. Make sure the on-off
switch [A] is in the OFF position and plug the power cord into a suitable
mains outlet.
2. Switch on the insect killer by moving the on-off switch [A] to the ON position.
5.

Cleaning and Maintenance

Warning! Never touch the metal grid with your bare hands. If you need
to clean the tray, follow the safety instructions carefully.
The cleaning frequency depends on the intensity of use. Check the tray of the
device at least once a week. Clean more often if necessary.
5.1

Discharging the Device before Maintenance

1. Unplug the device from the mains.
2. Use a screwdriver with an insulated handle. Make sure you hold the
screwdriver by the handle only.
3. Short-circuit the 2 wires of the inner metal grid by gently touching them
simultaneously with the metal shaft of the screwdriver. This may cause a
spark.
4. Repeat until no more sparks appear.
V. 03 – 21/11/2017
GIK07N/GIK08N/GIK09N/GIK16N
4 ©Velleman nv