Mounting Instructions - HoMedics DWS-400 Manual De Instrucciones Y Garantía

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TEMPERATURE, PRESSURE AND HUMIDITY
TREND INDICATORS:
You will see one of 3 icons;
will indicate Rising readings if it changes more than
1 degree or 1% relative humidity in an hour
will indicate Steady readings
will indicate Falling conditions if it is more than
1 degree 1% relative humidity in an hour
These readings are refreshed every hour.
TEMPERATURE ALERT
Press "ALERT" to turn temperature & humidity alert on
and off.
1. Hold "ALERT" button for 3 seconds to enter the alert
setting mode. The indoor icon will flash.
2. Press " +, - " to select the between indoor temperature or
remote sensor to be alerted to. The display will blink to
confirm your sensor selection.
Press "ALERT" to confirm
your selection. The Upper pointer and the value on the
LCD display will flash, enter the desired upper limit with
the " +, - " buttons, press "ALERT" to confirm your
selection and then go to the lower limit setting.
3. The Lower pointer and value will flash, enter the desired
lower limit with
" +, - " buttons, press "ALERT" to confirm and exit.
4. You may enter an alert setting for the indoor temp and for
each of the remote sensors.
5. When temperature hits the limit of your preset levels, the
Upper/Lower pointers and the temperature of the
respective channel (indoor or remote sensor) will flash
and an audible alarm will sound.
home receiver to acknowledge and stop the alarm.
6
Press any button on the
WEATHER FORECAST WITH STORM ALERT
The built-in sensor will read the atmospheric pressure and calculate the
weather conditions of the next 12 hours. These conditions will be displayed
as; Sunny, Partial Sunny, Cloudy, Rainy, Stormy, Icy at the top of the LCD
display.
LOW BATTERY INDICATION
Low battery indication is available for the home receiver and the remote
sensor. Replace the batteries and follow the setup procedure as mentioned
in this instruction manual.

MOUNTING INSTRUCTIONS

Both the Home Unit and Remote Sensor come with a table stand or they can
be wall mounted.
Table Top -
For the home unit, simply attach the stand provided.
For the remote sensor, simply fold out the attached stand from the mounting
bracket.
Wall Mounting -
For the Home Unit - Remove the table top stand from the bottom of the unit.
Fix a screw into the desired wall and place the home unit onto the screw
using the back side hanging hole.
For the Remote Sensor - Fix two screws into the desired hanging location
using the mounting bracket holes on the remote sensor as a template.
Ensure that the screws are placed vertically (in a straight line up/down)
along the surface and that there is proper distance between each screw to
hang the mounting bracket. Align the hanging holes of the mounting bracket
with the two screws and place unit onto the screws.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido