Commissioning And Operation - Klarstein SKYTOWER GRAND SMART Manual Del Usuario

EN
26

COMMISSIONING AND OPERATION

Before use
• Remove the appliance from its packaging and remove all packaging materials.
• Place the appliance on a stable and level surface.
• Insert the mains plug into the socket. The appliance can then be used directly and
no installation is required.
Commissioning
When the appliance's mains plug is plugged into the socket for the first time, the
appliance beeps twice and goes into standby mode. All indicator lights are off.
Switching appliance on/off
When you press the POWER button
When the appliance is switched on for the first time, the speed indicator (2) lights up.
The low speed indicator lights up and the swing function is disabled. Press the POWER
button again to put the appliance in standby mode.
Setting the speed
The speed button can be used to adjust the wind speed. Pressing the speed button
several times cycles through the speed levels in the following order:
Low > Medium > High > Low.
The speed levels are displayed in numbers on the screen:
Speed Display
Low 1
Medium 2
High 3
"Dry wind" function
If you press and hold the speed button
started. The LED indicator (2) lights up and flashes for 20 minutes. While using this
function, all buttons except the POWER button are inactive. Press and hold the speed
button for three seconds to cancel the function.
When the function has been activated for 20 minutes, the appliance automatically
switches off and goes into standby mode.
in standby mode, the appliance is switched on.
for 3 seconds, the "dry wind" function is