Commissioning And Operation - Klarstein MAXFRESH Manual De Instrucciones

EN
18

COMMISSIONING AND OPERATION

Installation
• Remove the unit from the packaging and check that the unit, the remote
control, 2 ice boxes and the 4 wheels are included.
• Install the wheels before operating the unit. To do this, press the shaft at the
end of the wheels into the recesses at the bottom of the unit (see picture).
Push the shaft in firmly until the roller is properly seated.
• Place the device on a level surface. Make sure that the socket corresponds to
the voltage indicated on the device plate.
Fill with water
• Unplug the power cord from the wall outlet.
• Pull the water tank out of the unit.
• Empty old water if you have not used the unit for a long time.
• Fill the tank to the Max mark at the maximum so that the tank does not
overflow.
Remote control
The keys on the remote control have the same functions as the keys on the control
panel.
Storage
If you are not going to use the unit for a long time, drain the water and let the
fan run at normal temperature for a while. After the unit is completely dry, put a
plastic bag over it and store it in the original box.