Kohler K-7127 Guia De Instalacion página 3

Installation
If present, remove and discard the protective plastic cap from
flange.
Remove the nut, friction washer, and seal from the drain body.
Apply a bead of plumbers putty or other sealant around the
underside of the flange according to the sealant manufacturer's
instructions.
Insert the drain assembly into the drain hole and press into place.
NOTE: For K-7127: A thin seal and a thick seal are provided with
your drain. Use the thin seal when installing the drain to lavatories
with a thick wall, such as vitreous china or cast iron. Use the thick
seal when installing the drain to lavatories with a thin wall, such as
stainless steel or copper.
Slide the seal (tapered side up) and the friction washer onto the
drain body.
NOTE: Do not to rotate the drain while tightening the nut.
Thread the nut up the drain body until snug against the
underside of the lavatory.
Using an adjustable wrench, tighten the nut. Do not overtighten.
Remove any excess putty or sealant.
Connect the P-trap (not provided) to the drain body.
Kohler Co.
Stopper
Flange
Drain
Body
Seal
Nut
Friction
Washer
3 1052943-2-C