Diamond GPE/210 Manual Del Usuario página 6

- Set the output tray (5).
- Check if the startup button (1) is in the OFF position.
- Connect the device to a single outlet.
- First, you must set the belt speed (3) and use the switches (2s) and (2i) to connect the desired
heating levels: upper and lower, leaving the appliance heat for 15 - 20 minutes.
Possible settings:
- Switch (2i): below toasting.
- Switch (2s): above toasting.
- Both switches (2s and 2i) above and below toasting.
- For a first testing, place 1 slice of bread. The higher the belt speed, toasting will be lighter and
vice-versa.
NOTE!: To toast wet products such as English muffins, bread or brown bread grain, reduce the
speed of the belt.
- The best results are obtained by choosing a medium level of speed of the belt.
- If the toaster is not in use, to save power, you can put the device in standby mode, using only the
lower heating level (2i), to save energy. For the device returns to normal mode of use (top and
bottom heating), you must connect the upper heating level (2s).
IMPORTANT: When operating the device, do not touch the metal parts, which are with high
temperatures.
ATTENTION
A. If there's a drop of water on the device, you must disconnect the appliance from the wall outlet
and dry thoroughly before using again.
B. For cleaning and maintenance of the appliance, it should always be disconnected from the
power supply. Use a soft cloth and never direct water for cleaning.
Maintenance and Clean
- Before making some cleaning operation, disconnect previously the appliance.
- Let the appliance cool down.
- Never submerse the device into the water or any other liquid. Use only a wet towel to clean the
device. Never use water jet - risk of electrical shock.
- Clean the device and the cable with a wet cloth, but never with abrasive products.
Routine inspection
- Routine inspections should be carried out every day. They can help to avoid accidents.
- Before usage, the unit should be checked for any damage on the controls and power cord.
- During operation, it should be checked for any peculiar smells or vibration.
Irregularities and Reparations
In case of damage of connection to the electric current, don't try to repair it; take the appliance to
the authorized Technical Service, once for that is necessary special tools.
The same thing is necessary to do, in case of some other irregularity.
- If the power supply cord is damaged, only the manufacturer, authorized agents or qualified
people for the job can replace it to avoid dangerous situations.
This appliance fulfils the principles of the Directive 73/23/CEE of Low Tension and the Directive
89/336/CEE of Electromagnetic Compatibility.
5