Echo SRM-225 Instrucciones De Instalación página 3

U-
handle
11. Position harness clamp (M) 220 mm (8-5/8 in.) from engine end of
drive shaft assembly. Install 5 x 12 mm bolt, but DO NOT tighten
at this time.
12. Carefully fit drive shaft assembly to engine making sure inner
drive shaft engages into clutch socket.
13. Tighten two (2) drive shaft clamp bolts (G) securely.
14. Install upper U-Handle and bracket on lower bracket and secure
with one (1) 8 x 55 mm bolt (N) and large circular washer.
15. Route throttle linkage and ignition lead assembly behind U-Handle
bracket and clip to drive shaft as shown.
16. Place inner throttle cable (E) in large hole of carburetor swivel (F).
17. Loosen nut (C) and place threaded end of throttle linkage in
bracket slot. Finger tighten nut (C).
18. Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly. If adjustment
cannot be achieved with adjusting nuts (C, O), consult with your
Echo Dealer for correct adjustment procedure. Tighten nut (C).
19. Connect 2 ignition stop leads (A,B) from throttle cable tubing to 2
ignition leads (A,B) on engine.
C K i
ombo it nstallation
i
nstrUCtions
400 mm
(15-3/4 in.)
220 mm
L
K
(8-5/8 in.)
G
N
E
F
O
C
D
A
B
3
M
G
P