AERMEC Srp ELESTA DOMOTESTA 300 Manual De Uso página 17

• Change of the value set for the zone temperature set:
24 24
22 22 2 2
20 20 4 4
18 18
6 6
16 16 8 8
14 14
10 10
12 12
• User programming procedures:
Dat.
A
1 2 3 4 5 6 7
Dat.
Dat.
24
22 2
20 4
18
6
16
8
14 10
12
Service
B
K
1-7 N
1 2 3 4 5 6 7
Dat.
Dat.
24
22 2
20 4
18
6
16
8
14 10
12
C
Service
K
1-7 N
3
ZONE TEMPERATURE SET CHANGE
1 1
2 2
3 3
4 4
1 1
2 2
3 3
-3 -3 +3 +3
DOMOTESTA 300
SYSTEM TIME AND DATE CHANGE
-3 +3
PC-Sercvice
D
-3 +3
PC-Sercvice
1
2
It is possible to modify the temperature set established for the zone,
using the potentiometer indicated in the figure; the setting carried
out with this command has been conceived as correction to the set
value; therefore, the change to the set is allowed within a range of
±3 °C.
To access the date and time setting function, press (
key is pressed, the (A) signal symbol will be displayed to the right
of the function printed on the left side of the regulation; after this,
remember that each time the key is pressed, the cursor will move
to the next function. To exit the function selection mode, scroll the
cursor up to the last function (service) and press the navigation key
again.
Once in the date and time programming mode, the current system
time (D) will be displayed; press (
the time is updated, press (
change; to change these parameters, press the increasing and
decreasing keys (the same used for the time parameter), remember
that the date format is day/month, the only value that is increased
or decreased in this parameter is the day, the month changes accor-
dingly. Press ( ) once more to go to the year display/change; to
N
modify the value, use the increasing and decreasing keys. Remember
that saving is automatic; the (C) parameter is an index that indicates
what is being displayed/changed:
1 = TIME
2 = DAY.MONTH
3 = YEAR
) or ( ) to modify the time; once
) to go to the day and month display/
N
); when this
17