The electronic control indicates the different operation modes of the unit and the system to the user; for this, some codes are
used to identify the operation mode or current errors; all these messages are displayed on the main screen (shown on page 6 of
Table of
Errors
contents
Er 1
Faulty boiler probe 1
Er 2
Faulty boiler probe 2 (below)
Er 10
Faulty external probe 1
Er 11
Faulty external probe 2
Er 12
Faulty ambient probe
Er 14
Faulty delivery probe
Er 21
Faulty return probe
Er 24
Faulty energy generator probe / return probe to the unit
Er 25
Faulty accumulator stopper probe 2
Er 28
Faulty flat-plate collector probe
Er 29
Faulty WP delivery probe
Er 31
General error of the energy generator
Er 32..36
Error 2 or 1 of the energy generator (high pressure)
Er 33..37
Error 2 or 1 of the energy generator (low pressure)
Er 34..38
Error 2 or 1 of the energy generator (safety series)
Er 35..39
Error 2 or 1 of the energy generator (geothermal probe pressure and flow, motor heating)
Er 40
Maximum temperature of the flat-plate collector exceeded
Er 41
Maximum power of the solar collector exceeded
Er 42
Antifreeze unit
Er 45
Faulty condenser probe of the unit
Er 46
Faulty suction gas temperature probe of the unit
Er 47
Unsuccessful defrosting
Er 48
Faulty evaporator probe of the unit
Er 49
Faulty geothermal temperature probe of the unit
Er 5Y
Regulator internal error
Er 6Y
Problems on the regulator bus.
Er 7Y
Problems on the system bus
Er 8Y
Interface error
ERROR MESSAGES
this manual); index 24).
Find below the meanings of the codes displayed on the screen
25