Warranty; Pre-Installation; Preparation - HAMPTON BAY HB7055-163 Guía De Uso Y Conservación

Warranty

The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship
for a period of three (3) years from date of purchase. This warranty applies only to the original
consumer purchaser and only to products used in normal use and service. If this product is found to
be defective, the manufacturer's only obligation, and your exclusive remedy, is the repair or
replacement of the product at the manufacturer's discretion, provided that the product has not been
damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling. This
warranty shall not apply to any product that is found to have been improperly installed, set-up, or
used in any way not in accordance with the instructions supplied with the product. This warranty
shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence,
alteration, or faulty installation, or any other failure not relating to faulty material or workmanship.
This warranty shall not apply to the finish on any portion of the product, such as surface and/or
weathering, as this is considered normal wear and tear. The manufacturer does not warrant and
specially disclaims any warranty, whether expressed or implied, of fitness for a particular
purpose, other than the warranty contained herein. The manufacturer specifically disclaims
any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor/expense costs involved in the replacement or repair of
said product.
Contact the Customer Service Team at 1-877-527-0313 or visit www.hamptonbay.com.

Pre-Installation

PREPARATION

WARNING: Before starting installation
of this fixture or removal of a previous
fixture, disconnect the power by turning
off the circuit breaker or by removing
the fuse at the fuse box.
To ensure a successful installation, be sure to
read these instructions and review the diagrams
thoroughly before beginning.
Prior to fixture installation, install a recessed
outlet box into the wall surface at the desired
location. It is recommended to use a standard
recessed 4" octagonal outlet box, as shown in
Fig. 1. The mounting hardware that comes with
this fixture may not be compatible with an outlet
box different from the 4" octagonal. Be sure to
check for compatibility with the mounting
hardware before installing any outlet box.
After installing the outlet box, run wiring from the
home's 120 volt power source into the outlet,
making sure to follow the local jurisdiction's
electrical code.
WARNING: If you are uncertain,
consult a qualified electrician if you
have any electrical questions.
Be sure to leave 6" of wiring extending out from
the outlet box.
Fig. 1
3
Please contact 1-877-527-0313 for further assistance
HAMPTONBAY.COM