Tuner Operation; Select A Band; Preset Stations - Jensen JHD40BT Manual De La Instalación Y Operación

JHD40BT

TUNER OPERATION

5
1
VOL +
1/
UP
17
MUTE
SEEK INFO
2/
RPT
/TUNE ENTER
3 AUDIO /TRK
MENU
DOWN
3/
INT
VOL -
16 BAND
SEARCH
2a
6 7 13 2b

Select a Band

Press the BAND/SEARCH button (16) to change between three FM bands and two AM (MW)
bands.
Manual Tuning
Press the SEEK/TUNE/TRK |<< or >>| buttons (13, 14) to seek stations up/down step by step.
Auto Seek Tuning
Press and hold the SEEK/TUNE/TRK |<< or >>| buttons (13, 14) to automatically seek the next
or previous strong station.

Preset Stations

Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Press and hold a preset button (5-10) for two
seconds. The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (5-10) to select the corresponding stored
station.
20
JHD40BT 8
DISP 12
SCROLL
4/ RDM
EQ 11
LOUD
SEEK
5/
/TUNE
15
/TRK
AS/PS
6/
4
MODE
18 14 10 9 19
Automatically Store / Preset Scan (AS/PS
Automatically Store
Select an AM or FM band. Press and hold the AS/PS
to automatically select strong stations and store them in all bands. The new stations replace
any stations already stored in that band.
Preset Scan
Select a band (if needed). Press the AS/PS
The unit will pause for ten seconds at each preset station. Press AS/PS
scanning when the desired station is reached.
7
)
button (15) for more than 2 seconds
button (15) to scan stations stored in all bands.
again to stop