GE Kinsey 20444 Manual Del Usuario página 9

WIRING DIAGRAM 3:
Wiring Configuration with more than 1 of the same
colored wires in
the outlet box
(L1) W
G-ground
(L2)
When multiple wires are connected together, use a
solid wire 12-14 AWG jumper lead to insert into the
receptacle terminal.
NOTE: Be sure to push each wire from ceiling all the
way into corresponding terminal on powerplug. If
wire is not inserted completely, there is a possibility
that the electrical connection will fail. If you have
multiple wires connected together, add a jumper lead
and insert jumper lead into terminal. One single wire
is inserted into terminal.
INSTALLING THE POWERPLUG RECEPTACLE
1.
C
A
Use metal outlet box (sold separately) suitable
for fan support. Secure outlet box directly to
the building structure using wood screws (A)
and star washer (C). Outlet box must support
(35 lb.) min.
DANGER: A loose outlet box can cause the
fan to wobble and increase the fan's
potential to fall, which could result in
serious injury or death.
Fan Installation
black
WIRE NUT
white
white
green
C
A
WARNING: To avoid possible
electric shock, be sure electricity is
turned off at the main fuse box
before wiring.
NOTE: Fan must be installed at
a maximum distance of 6 m (20
ft.) from the transmitting unit for
proper signal transmission between
the transmitting unit and fan's
receiving unit.
CAUTION : Do not use wall switch
with dimmer function.
WARNING : Do not use an existing
mounting bracket in the outlet box,
replace it with the powerplug
receptacle that is included with the
fan.
View Installation Video@
www.gelightingandfans.com
2.
Q
E
B
Install powerplug receptacle (Q) to outlet box
using the mounting screws (with lock washer)
(BB) and flat washers (CC) provided with the
outlet box. (Two additional mounting screws
(with lock washer) (BB) and flat washers (CC)
are provided in the hardware bag).
NOTE: The placement of the powerplug
receptacle on the ceiling is important for the
fan plug to make the correct installation and
securement. The powerplug receptacle should
be evenly flush with the ceiling. Use the rubber
washers as shown in the figures on next page.
Rubber Washer
9