Hanging The Fan - GE Kinsey 20444 Manual Del Usuario

HANGING THE FAN

1.
Rubber insert
Remove the rubber insert located on the
canopy mounting screws (X) on both
sides before installation.
3.
X
Rotate the canopy to the right (clockwise),
continue turning the canopy until the
canopy mounting screws (X) lock into place
on the powerplug j slots (see fig. 2).
Note: You may need to loosen the canopy
mounting screws (X) slightly, if you find it's
difficult to lock the screws into the
powerplug j slots.
Fan Installation
2.
Q
Locking pin terminal
Plug locking
pin
X
To install the fan, make sure the canopy trim ring is placed
on the fan housing, raise the assembled fan housing up to
the ceiling receptacle (Q). Press up on the push lever while
lifting the fan canopy up to the receptacle (Q) fully
inserting the fan plug locking pin into the receptacle
locking pin terminal. For correct alignment, make sure
the mounting bracket push lever on the canopy is placed
in the middle between the receptacle j slots as shown in
the picture. Keep the lever pushed up while turning the
fan to the right (clockwise) as shown in step 3.
4.
Tighten all the 4 canopy mounting screws
(X).
J slot
Mounting bracket
push lever
Canopy
Canopy trim ring
5.
X
Secure the decorative ring in place. Pass the
mounting bracket push lever through the slotted
hole on the canopy trim ring. Take both hands
and push the canopy trim ring up to the top of
the canopy. The canopy trim ring will snap and
lock into place on the canopy. Position the
canopy trim ring to eliminate any gap if needed.
Mounting bracket
push lever
Slotted hole
11