Installation - Tripp-Lite SRCOOLNET2LX Guía De Instalación E Inicio Rápido

Installation

The SRCOOLNET2LX allows a user to communicate with and control Tripp Lite's
SRCOOL2KWM, SRCOOL7KRM, SRCOOL18K, SRCOOL24K (pre-installed in unit) spot
coolers, and compatible SRCOOL33K row-based cooler as manageable devices on a
network accessible via Web browser, network management station, telnet, SSH or
command line.
1 - Preparation
Confirm Package Contents: In addition to this manual, your package should
1-1
include the following:
• Micro-USB cable for remote temperature sensing and configuration
(part number: 73176E), 12 ft.
• EnviroSense2 E2MT Sensor Module
• E2MT User Manual
Locate MAC Address: The 12-digit MAC address (000667xxxxxx) is located on
1-2
the SRCOOLNET2LX.
2 – Installation
Insert the SRCOOLNET2LX into the front SNMP accessory slot on the
2-1
SRCOOL2KWM/7KWM/18K/24K spot coolers or compatible SRCOOL33K
row-based cooler (Figure 1 in section
Connect SRCOOLNET2LX to Network: Connect a standard Ethernet patch
2-2
cable to the RJ45 Ethernet port on the SRCOOLNET2LX.
Note: This port does not support PoE (Power over Ethernet) applications.
Determine Network Installation Method: If your network's DHCP server will
2-3
assign a dynamic IP address to the SRCOOLNET2LX automatically, proceed to
3 - Dynamic IP Address Assignment. If you will assign a static IP address to
the SRCOOLNET2LX manually, proceed to 4 - Static IP Address Assignment. If
you are uncertain which method to use, contact your network administrator for
assistance before continuing the installation process.
18-06-379-93387E.indb 2
4-2 ).
2
7/26/2018 4:19:58 PM