Tripp-Lite SRCOOLNET2LX Guía De Instalación E Inicio Rápido página 3

Installation
3 - Dynamic IP Address Assignment
Connect SRCOOLNET2LX to Network: By default, the SRCOOLNET2LX will
3-1
attempt to obtain an IP address via DHCP . This may take as long as several
minutes, depending on your network environment.
Discover IP Address: To identify the IP address assigned to the
3-2
SRCOOLNET2LX, contact your network administrator and provide the MAC
address of the SRCOOLNET2LX. You can also determine the IP address locally at
the card. If you do not already have the serial over USB driver installed on your
PC, you can download it from www.tripplite.com/support by typing
SRCOOLNET2LX in the search field. Select the driver named "TL-cdc". To install,
follow the instructions provided with the driver.
Once the driver is installed and the COM port has been assigned, start a
terminal emulation program, such as Tera Term Pro. Configure it to use the
assigned COM port and use the following serial port settings: 115.2Kbps, 8,
NONE, 1. Connect the USB cable to the PC and the Micro-USB end to the
Micro-USB port on the SRCOOLNET2LX. When the login prompt appears, login as
localadmin / localadmin. When the Menu appears, navigate to "3- Network
Configuration", then to "1- IP Configuration". The assigned IP address will be
displayed. After you have determined the IP address, proceed to section 5 - Test
and Configure.
Notes:
• Usernames and passwords are case sensitive.
• You may wish to request a long-term lease period for the IP address, depending on your
application.
• PowerAlert ®
is set up by default to receive a DHCP address for IPv4, IPv6 or both. Receiving both
addresses allows connection to the card via either the IPv4 or IPv6 address.
18-06-379-93387E.indb 3
Device Manager and the WEBCARDLX support both IPv4 and IPv6. The card
3
7/26/2018 4:19:58 PM