Instructions For Use; Start Cleaning - Roborock S6 MaxV Manual De Usuario

Instructions for use

On/Off
Press and hold the button to power on the robot. The power indicator
will turn on and the robot will enter standby mode. When the robot is
idle, press and hold the button to turn off the robot and complete the
cleaning cycle.
Note:
The robot cannot be turned off when it is being charged.

Start Cleaning

Press the button to start cleaning. The robot will plan its cleaning
route according to its scan of the room. It splits a room into zones, first
draws out zone edges, then fills the zone in a zigzag pattern. In so doing,
the robot cleans all zones one by one, efficiently cleaning the house.
Zone 1 has
been cleaned.
Zone 4 is
pending.
Zone 1 has
been cleaned.
Zone 3 is
being cleaned.
Note:
・
Cleaning cannot start if the battery level is too low. Allow the robot to charge before restarting cleanup.
・
Before cleaning, tidy cables (including the power cable of the Charging Dock) from the floor. Loose cables
may be dragged by the robot, resulting in the disconnection of electrical appliances or damage of cables
・
and property.
・
If cleaning is completed in less than 10 minutes, the area will be cleaned twice.
If the battery runs low during the cleaning cycle, the robot automatically returns to the Charging Dock.
After charging, the robot will resume where it left off.
Pause
When the robot is running, press any button to pause it.
Then press the button to continue cleaning or the
return it to the Charging Dock and stop the cleaning cycle.
Note:
Placing a paused robot on the Charging Dock manually will end the current cleanup.
Sleep
If the robot is paused for over 10 minutes, it will go to sleep, and the
power indicator will flash every few seconds. Press any button to wake the
robot up.
Note:
・
The robot will not go to sleep when it is on the Charging Dock.
・
The robot will automatically shut down if left in sleep mode for more than 12 hours.
23
button to