Start Cleaning; Instructions For Use - Roborock E5 Manual Del Usuario

Installation

Start cleaning

6
When the battery is fully charged, the Power Indicator will
remain lit. Press the button or use the app to start a
cleanup.
Remove the mopping module
7
After the machine completes cleaning and returns to the
charging dock, press the two side latches inwards and pull to
remove the mopping module.
Note:
• When the charging dock is placed on a wooden floor, always use it with the moisture-
proof mat to prevent moisture damage.
• Remove the mopping module after mopping, empty residual water and clean the mop
cloth to prevent mildew or unpleasant odors.
• Remove the mopping module if not mopping.

Instructions for Use

On/Off
Press and hold the button to power on the robot. The Power
Indicator will turn on, and the robot will enter standby mode. If
the robot is idle, press and hold the
end the current cleaning cycle.
Note: The robot cannot be turned off when it is charging.
Clean
Press the button to start cleaning. Press any button to pause
the current cleaning cycle.
Note:
• Cleaning cannot start if the battery level is too low. Allow the robot to charge before
restarting cleanup.
• Tidy away any cables on the ground (including the Charging Dock Power Cable) before
cleaning to avoid losing power or damaging either the robot or the cables.
• If a cleanup finishes within 10 minutes, cleaning repeats by default.
• If the battery runs low before cleanup is complete, the robot will return to the dock for a
top-up charge before resuming cleanup from where it left off.
21
button to power it off and