Instructions For Use - Roborock S4 Manual Del Usuario

Instructions for use

On/off
Press and hold the button to turn on the robot. The power
indicator will turn on, and the robot will enter Standby mode. If the
robot is asleep, press and hold the
the current cleanup.
Note: The robot cannot be turned off when it is charging.
Start cleanup
Press the button to start a cleanup. Once started, the robot will
plan its cleaning route based on its scan of the area. It cleans
along the wall of a zone first and then moves in a Z-shaped
cleaning route to cover the whole area efficiently and thoroughly.
Zone 1: Clean
Zone 4: Pending
button to turn it off and end
Zone 2: Clean
Zone 3: Cleaning
Note:
Cleaning cannot start if the battery level is too low. Allow the robot to charge before
restarting cleanup.
Tidy away any cables on the ground (including the power cable of the charging dock)
before cleaning to avoid losing power or damaging either the robot or any connected
devices.
If a cleanup finishes within 10 minutes, cleaning repeats by default.
If the battery runs low before cleanup is complete, the robot will carry out a top-up charge
before resuming cleanup from where it left off.
Pause
When the robot is cleaning, press any button to pause it.
Then press the button to continue cleaning or the
the cleanup and send it back to the dock.
Note: Placing a paused robot on the charging dock manually will end the current cleanup.
Sleep
If the robot is paused for over 10-minutes, it will go to sleep, and its
power indicator will flash slowly. Press any button to wake it back up.
Note:
The robot will not go to sleep when it is on the charging dock.
The robot will shut down if left asleep for over 12-hours.
014
button to stop