Front Runner FAJK007 Manual Del Usuario página 7

4 FIT AND SECURE
3.4
3.5
3.6
FAJK007 / FAJK008_REV_A00
4
80mm
13mm
7
Clean the area around all the 22mm holes
drilled in the roof with a rag and
methylated spirits/denatured alcohol.
Insert the Aluminum Spacers (Item 8)
into the Foam Washer (Item 9). Remove
the paper backing from the Foam washer
to expose the adhesive.
Insert the washer/spacer assembly,
adhesive side down, into the 22mm holes
so that the spacer comes to rest on the
Rear Support Brackets underneath.
Firmly press the foam washer all the way
around securing it to the roof.
If not already assembled, assemble your
Tray as per the Universal Tray Assembly
Instructions (Document RRSTUNI)
NOTE: Before fitting the Wind
Deflector, insert two M8 x 16 Hex
Bolts (Item 16 from FAJK008) or
(Item 1 from FAJK007) into the first
slat (Combined Slat), using the
Machined slots. Slide a bolt to each
of the outer corners.
After fitting the wind deflectors, the tray
should still be upside down, loosely
mount the Foot Rails (Item 17L & 17R
from FAJK008 box) to the Tray using M8
x 16 Hex Bolts, M8 X 16 X 1.6SS Flat
Wahsers and M8 Nyloc Nuts (Items 16,
18 & 19). As before use the machined
slots to insert the hex bolts into the
Slats. The Foot Rail should be mounted
at the opposite end of the Tray to the
wind deflector.
The rear of the Foot Rail must mount
onto the very last Slat (Combined Slat)
and approximately 80mm in from the
outer edge of the side of the Tray. Do not
tighten the bolts yet.
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
13mm