Front Runner FAJK007 Manual Del Usuario página 8

MOUNT YOUR TRAY
6
6.1
Half Rack Shown
6.2
REMOVING YOUR RACK
5
5.3
FAJK007 / FAJK008_REV_A00
4
12
12
2RH
11
5
15
8
With the help of a friend, flip the Tray
end over end so that it is in the upright
position. (The Tray is flipped end over
end so that bolts and brackets do not
slide left and right).
With one of you on either side of the
Tray, lift the Tray and walk it into
position above the vehicle, approaching
from either the front or the rear of the
vehicle.
The Foot Rail should still be loose
enough to move. Line the brackets up
with the holes on the roof and fasten
them into position using M6 x 30 Hex
Bolts, M6 x 19 x 1SS Flat Washers, M6 x
10mm
12 x 1SS Flat Washers and M6 Nyloc
Nuts (Items 6, 7, 11 & 12). Centre the tray
from left to right. Use a tape measure to
double check. Once you are happy that
the Tray is in the correct position, fasten
all the nuts and bolts, both inside and
outside of the vehicle on all brackets
that were installed.
Place M6 Nut Caps (Item 5) over all the
10mm
exposed bolts and close up all the roll
bar padding.
Should you wish to remove your rack,
you will need to plug the holes you
drilled in the roof (Step 3.4), using the
supplied Sealing Plug Assemblies.
Remove the Tray, Front Uprights and the
Foot Rail, by reversing the instillation
procedure. Leave the Foam Washer and
the Aluminum Spacers in place. Screw in
the Sealing Plugs reusing the M6 Nyloc
Nuts and Washers that held the Foot Rail
in position.
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
13mm