Naxa NX-831 Manual De Instrucciones página 10

HDCD
Set HDCD is "off ","1X","2X "
LAST MEMORY
Press " setup" button from remote controller and press " last memory " to " on". This
function is now enabled. You can now put a disc into player, and after playing 8 seconds or
more ,press " standby " button or " power off " ... when u play the disc again, it will begin
playing from the position where it last stopped, If this function is NOT enabled then the
disc will not continue from the last memory position.
AUDIO SETUP
Includes Speaker setup , spdif setup.
SPEAKER SETUP
Include DOWNMIX, FRONT SPEAKER, CENTER SPEAKER, REAR SPEAKER, SUBWOOFER.
DOWNMIX
Set the audio output in
FRONT SPEAKER
Set the speaker in
CENTER SPEAKER
Set the speaker in
REAR SPEAKER
Set the speaker in
SUBWOOFER
Set the speaker in
SPDIF SETUP
Spdif output,Audio digital signals can be output through COAXIAL and OPTICAL in rear
panel.There are 3 optinal audio output modes:spdif off,spdif/rawand spdif/pcm.
a) SPDIF / OFF: From the Coaxial Output jack and the Optical Output jack, no
signal is output.
b) SPDIT/RAW: Choose this setting if your DVD player is connected to a power
amplifier with coaxial cable or an optical cable. When playing a disc
recorded with Dolby Digital, and MPEG audio formats, the corresponding
digital signals will be output from the Coaxial Output jack or Optical Output
jack. This players digital output jacks are designed for a connection to a
Dolby Digital, or MPEG receiver or decoder.
c) SPDIF/PCM: Choose this setting if your DVD player is connected to a
2-channel digital stereo amplifier; When playing a disc recorded whit Dolby
Digital and MPEG audio formats, audio signals will be modulated into a
2-channel PCM signal, and it will be output from the Coaxial Output jack or
Optical Output jack.
.
General Audio Dolby Video Preference
- - Audio setup page - -
Downmix
Spdif output
Go To audio setup page
Lt/Rt , Stereo or Off mode.
Large or Small mode.
Large , Small or Off mode.
Large , Small or Off mode.
On or Off mode.
-7-