Maintenance - RedMax SRTZ260F Manual De Instrucciones

9. Maintenance

Maintenance, replacement, or repair of the emission control device and systems may be performed by any
non-road engine repair establishment or individual.
■ MAINTENANCE CHART
system/compornent
fuel leaks, fuel spillage
fuel tank, air filter, fuel filter
idle adjusting screw
spark plug
cylinder fins, intake air cooling vent
muffler, spark arrester, cylinder exhaust port clean
throttle lever, ignition switch
cutting parts
bevel gear case
screws/nuts/bolts
■ GEAR CASE
There is a grease nipple for filling lubricant on the gear housing.
Use a grease gun to fill with grease.
Use Shell Gadus S2 V220AC2 grease.
IMPORTANT
The gear housing must not be filled completely with grease. The
grease expands as the machine heats up during operation. If the
gear housing was completely filled with grease it could damage
the seals and lead to leakage of grease.
The grease in the gear house does not normally need to be
changed except if repairs are carried out.
every
25
procedure before hours
use after
✔
wipe out
✔ ✔
inspect/clean
see ■ADJUSTING
✔
IDLING SPEED (p.11)
clean and readjust
plug gap
✔
clean
✔
check operation
replace if
✔
something's wrong
✔
grease
✔
tighten/replace
every every
50 100
hours hours note
after after
replace, if necessary
replace carburetor
if necessary
GAP: .025in(0.6~0.7mm)
✔
replace, if necessary
✔
✔
not adjusting screws
■ BLADES
Clean any resin and plant residue from the blades using cleaning
agent 531 00 75-13 (UL22) before and after using the machine.
Lubricate the blade bars with special grease, part no. 531 00 75-
12 (UL 21) before long periods of storage.
IMPORTANT
Use only RedMax replacement parts. Use of other brands of
replacement parts can cause damage to your unit or injury to the
operator or others. Your warranty does not cover damage or
liability caused by the use of accessories and/or attachments not
specifically recommended by RedMax.
SRTZ260F
U
S
US-13