DeWalt DW979 Manual De Instrucciones página 11

DW979,159361-02,00 5/8/02
Intalling and Changing Nutsetters and
Locators
1. Select nutsetter size desired.
2. One locator is supplied (a 9/16" ID for 3/8" and 5/16" nutsetters).
3. Drop nutsetter into nose of locator and wrap the end of nutsetter
until ball lock snaps in groove in nutsetter shank.
4. To change the nutsetter or locator, pull forward on adustment collar
and remove from clutch housing.
5. Pull nutsetter straight out with pliers if it is difficult to remove.
6. Assemble nutsetter as shown in FIG. 7.
7. Reassemble adjustment collar. Align ribs on inside of depth locator
with grooves in clutch housing.
Depth Adjustment on Depth Sensitive
Units for Drill Point Screws
1. For washer head screws: Rotate adjustment collar until end of
nutsetter is flush with end of locator.
2. For large washer head and sealer screws: adjust as above until
nutsetter is recessed approximately 1/16" into the locator.
3. Test drive a fastener in scrap material to determine if seating is
correct.
4. Readjust if necessary.
Maintenance
CLEANING
With the motor running, blow dirt and dust out of all air vents with dry
air at least once a week. Wear safety glasses when performing this.
Exterior plastic parts may be cleaned with a damp cloth and mild
detergent. Although these parts are highly solvent resistant, NEVER
use solvents.
Depth locator and adjustment collar should be removed and dust
blown out of clutch area housing at least once a week.
9:56 AM Page 8
Accessories
Recommended accessories for use with your tool are available at extra
cost from your local service center.
CAUTION: The use of any non-recommended accessory may be
hazardous.
If you need any assistance in locating any accessory, please contact
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286 or call 1-800-4-D WALT. (1-800-433-9258)
E
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Full Warranty
D WALT heavy duty industrial tools are warranted for one year from
E
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information, call
1-800-4-D WALT. This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, D
E
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
D WALT heavy duty industrial tool, simply return it to the participating
E
seller within 30 days for a full refund. Please return the complete unit,
transportation prepaid.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-DEWALT for a free
replacement.
8
WALT tools are covered by our: