Shutdown Instructions; Test Firing Heater & Storage; Maintenance Instructions; Replacement Parts - Dyna-Glo FA 60 Serie Manual Del Usuario E Instrucciones De Operación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

PROPANE CONSTRUCTION HEATER

WARNING

: Motor and fan must be running before lighting, during operation and at shutdown,

in order to prevent a flame-out condition which could result in personal injury or property damage.

1. Turn gas valve knob clockwise

2. Turn gas supply OFF by turning propane tank valve clockwise

3. Keep the heater running for 30 seconds to get the excess heat out before turning it OFF.

4. Toggle the ON/OFF switch to the OFF " " position to turn off the fan motor

5. Disconnect the power cord once the heater has cooled to ambient temperature.

Test fire your construction heater, following the lighting instructions applicable to the gas control

system employed. Leak test all gas connections with soap solution. Soap bubbles indicate gas

leakage. DO NOT use a match or flame to test for gas leaks.

Never store a Propane gas tank inside a building or in the vicinity of any gas or oil burning appliance.

When the Propane tank is not disconnected from the construction heater, the gas tank and heater

must be stored outdoors in a well ventilated area, out of the reach of children. If for any reason the

heater is to be stored indoors, the tank must be disconnected and stored outdoors in a well ventilated

area out of reach of children, in accordance with the standard for the the Storage and Handling of

Liquefied Petroleum Gases, ANSI / NFPA 58 and CSA B149.1, Natural Gas and Propane Installation

Code. The plastic tank valve plug supplied with your tank must be tightly installed when the tank is

disconnected from the heater.

1. Turn unit off, allow heater to fully cool and disconnect propane hose before performing any

maintenance functions. Unplug the unit from the 120V receptacle.

2. Keep unit clean and keep the inside of the torpedo housing debris free.

3. Have unit checked by a qualified technician at least once a year, preferably prior to the

heating season.

Warning: Use only original replacement

parts. This Heater must use design-specific

parts. Do not substitute or use generic parts.

Improper replacement parts could cause

serious or fatal injuries.

This will also protect your warranty coverage

for parts replaced under warranty.

Parts warranty and non-warranty: Contact

authorized dealers of this product. If they can

not supply original replacement part(s), either

contact your nearest Parts Central or GHP

Group Inc., Technical Service Department at

1-877-447-4768.

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!