LUCCI Air AKMANI Manual Del Usuario página 8

Akmani Installation Instructions
Transmitter / Receiver pairing for Ceiling fan 2:

Turn off the mains supply to the receivers of both ceiling fans 1 and 2.

Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Fig.12

Change the position of the DIP switches in the transmitter 2, so that it will be different to transmitter 1.

Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
 Press and hold the "
ON to the receiver of ceiling fan 2.

Once the transmitter is paired with the receiver of ceiling fan 2, it will make a beep sound twice. Turn ON
and change the speed of the ceiling fan 2 by the transmitter 2 to check the operation and successful
pairing.
Remote Control Buttons
: FAN ON/OFF BUTTON: Press the button to turn the fan on/off.
+: SPEED INCREASE BUTTON: Press the button to increase the fan speed. The LED
indicator will indicate the fan speed (1-6 speed) accordingly.
-: SPEED DECREASE BUTTON: Press the button to decrease the fan speed. The LED
indicator will indicate the fan speed (1-6 speed) accordingly.
: REVERSE FUNCTION BUTTON: Press the button to activate the reverse running
function. The fan must be operating to activate the reverse function.
: NATURAL FLOW BUTTON: Press the button to set the fan running at changing speed
automatically. If the fan is working at speed 1, 2, 3, then press this button to let the fan run
at a lower changing speed. If the fan is working at speed 4,5,6, then press this button to let
the fan run at a higher changing speed.
: LIGHT CONTROL BUTTON: Press the button to turn on/off the light. (not valid)
When pressing the remote button, the LED indictator 1(
need to replace the battery with a new 12VDC battery.
When pressing the remote button, if the receiver receives the signal well, it will make a beep sound.
7 | P a g e
" button of transmitter 2 for 6 seconds within 60 seconds of switching the power
) will be on. If the LED indicator 1 is off, then you
Fig. 13