Parameterizing The Machine - Furius FIX 251 Manual De Instrucciones

Instructions for setting and parameterizing the machine
9.
In MMA (stick welding) mode)
Use the button to switch between current parameters
(AMP), Arc Force, and VRD.
Press and hold the button
flashes
Press again
led) and TIG (right led) and wait for it to stop flashing to
confirm the selection.
With the indicator LED in AMP (current):
Turn the knob to adjust the current.
The display will show the adjusted current value.
With the indicator LED on ARC FORCE:
Turn the knob to adjust the arc force (between 0 and 10). The arc force will
increase the arc power to correct sudden movements of the electrode and
improve the stability of the arc.
With the indicator LED in VRD:
Turn the knob to activate (ON) or deactivate (OFF) the VRD.
The VRD is a technology that decreases the machine's open circuit voltage to
safe levels to avoid the risk of operator electrocution when using the machine
in risky environments.
until the process selection indicator LED
to enter the process change function
to switch between MMA (stick welding, left
16