EAS ELECTRIC EMD143X Manual De Instrucciones página 75

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Step 4. Dishwasher installation steps
Please refer to the specified installation steps in the installation
Please refer to the specified installation steps in the installation
drawings.
drawings.
1. Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into position. (Step 4)
6. Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher
by turning the screw in the middle of the base of dishwasher. To adjust the front
feet, use a flat screw driver and turn the front feet until the dishwasher is level. (Step
5 to Step 6)
7. Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 10)
8. Adjust the tension of the door springs by using an Allen key turning in a clockwise
motion to tighten the left and right door springs. Failure to do this could cause
damage to your dishwasher. (Step 11)
9. The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface: Put the installation hook into the slot of the side plane and
secure it to the work surface with the wood screws.
B. Marble or granite work top: Fix the side with Screw.
A
B
24
V.1

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido