Cleaning And Maintaining The Device; Disposal; What If There Are Problems - Beurer GS 80 Instrucciones Para El Uso

If you step off the standing surface, the scale switches off after 10 seconds. The measurement remains visible
during this period.
If the maximum capacity of the scale (150 kg) is exceeded, "

8. Cleaning and maintaining the device

The device should be cleaned from time to time.
This should be done using a damp cloth and, if necessary, a small amount of detergent. Do not use any abra-
sive cleaning products and never submerge the device in water.
Important:
• Never use abrasive solvents or cleaning agents!
• Never submerge the device in water!
• Do not clean the device in the dishwasher!

9. Disposal

Batteries must not be disposed of with household waste. As a consumer, you are required by law to recycle
used batteries. You can recycle your old batteries at public collection points in your community or wherever
batteries of the relevant type are sold.
Note:
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Observe the local regulations for material disposal.
Dispose of the unit in accordance with EC Directive 2002/96/EC – WEEE (Waste Electrical and Elec-
tronic Equipment). If you have any questions, please contact the local authorities responsible for
waste disposal.

10. What if there are problems?

If the scale encounters an error during measurement, the following is displayed:
Display Cause
0_Ld Maximum capacity of 150 kg exceeded. Loads must be limited to 150 kg.
Lo Batteries are almost empty.
CAL The scale is fi nding its zero point.
Inside temperature < -10 °C
LL:L
Outside temperature < -50 °C
Inside temperature > 50 °C
HH:H
Outside temperature > 70 °C
No measurement possible
Possible faults
The scale was not activated before stepping
onto it. If you stand on the scale before the
0. 0 kg", the scale will not
display shows "
function correctly.
10
o_LD " appears in the display.
Solution
Replace the batteries in the scale.
Wait until "
Inside or outside temperature outside meas-
urement range.
Inside or outside temperature outside meas-
urement range.
Solution
Correctly activate the scale (wait for "
displayed) and repeat the measurement.
If necessary, wait 30 seconds and then repeat the
measurement.
0. 0 kg" is displayed.
0. 0 kg" to be