Health O Meter 500KL Instrucciones De Uso página 8

500KL ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling the 500KL Scale (Refer to Figures 1 - 11)
Caution: It is recommended that the assembly be performed by two persons.
1. Carefully remove the scale platform C and columns A and B from the carton. Place the scale
platform and columns on a flat, level, and dry surface (see Figure 1).
2. Remove the 4 small screws and washers from the bottom of column B (see Figures 1 & 2).
3. Locate cable connector inside column A (see Figures 1 & 3).
4. While holding column A, slide the cable connector through the top of column B. The top of
column B has a notch (see Figures 1 & 5).
5. Plug the cable connector into the RJ jack, located on the scale platform C
Note:
Ensure that the cable connector is correctly plugged into the RJ jack.
6. Align column A and column B. Snap the locking tab into place. Ensure that the locking tab is
locked securely into place (see Figures 1 & 5).
7. Position and secure the connected columns A and B to the scale platform C.
8. Insert the 4 small screws through the bottom of the scale platform C screw holes and into
column B. Ensure that washers are located between the screw heads and the scale platform
C screw holes (see Figures 1, 6, & 7).
9. Using a Phillips head screwdriver, tighten the screws to secure column B to the base of the
scale platform C (see Figure 1, 6, & 7).
Note:
Ensure that the screws are fully tightened to prevent damage to the scale.
10. Locate the upper height rod D and lower height rod E from the carton (see Figure 1).
11. Align the upper height rod D with the lower height rod E. Snap the locking tab into place.
Ensure locking tab is securely locked (see Figures 8 & 9).
12. Position the bottom of the fully assembled height rod into the height rod opening G at the top
of the upper column A. Press locking tab F inward to insert the height rod into the height rod
opening G (see Figures 1 & 10).
13. The scale is now assembled and ready for use (see Figure 11).
8
see Figures 1 & 4).
(