D-Link DCS-6510 Guía De Instalación Rápida página 13

6. Adjusting the Zoom/Focus
Adjust the Viewing Angle of the 3-Axis
Mechanism
Turn the lens module left and right until the
desired position is achieved; tighten the pan
screw once completed.
Loosen the tilt screws on both sides of the
camera, and turn the lens module up and down
until the desired position is achieved; tighten
the tilt screws once completed.
Turn the lens to adjust the IP camera's image
until the desired orientation is achieved, tighten
the image adjustment screw once completed.
Adjust Zoom and Focus of the Lens Module
Loosen the zoom controller and adjust the
zoom factor by moving the controller left
and right until the desired range is achieved.
Tighten the zoom controller once completed.
Loosen the focus controller and adjust the
focus range by moving the controller left and
right until the image is clear. Tighten the focus
controller once completed.
11
D-Link DCS-6510 Quick Install Guide